Step 1 – Rinse the Activated Carbon: Place the activated carbon in a filter and rinse it thoroughly with cold water. This will help remove any loose particles or dust that may have accumulated during storage.
Step 2 – Soak the Activated Carbon: Fill a large container with cold water and add the activated carbon. The ratio of water to activated carbon should be approximately 5:1. Stir the mixture with a spoon, making sure the activated carbon is completely submerged.
Step 3 – Stir the mixture: Allow the activated carbon to soak for at least 30 minutes, stirring the mixture every 5-10 minutes. This will help loosen any impurities or contaminants that may be present.
Step 4 – Filter the mixture: After soaking, pour the mixture into a filter to separate the activated carbon from the water. Be sure to press on the activated carbon to remove any excess water.
Step 5 – Rinse the Carbon: Rinse the activated carbon again with cold water, making sure all impurities are removed.
Step 6 – Dry the Carbon: Spread the activated carbon on a clean towel or paper towel and allow it to air dry completely.
You can also dry it in the oven on a low heat setting (about 100°C) for 20-30 minutes.
Step 7 – Storing the Carbon: Once the activated carbon is completely dry, store it in an airtight container until you are ready to use it for distillation.
